Energy meter; Single-phase two-wire, three-wire; Accuracy: 0.1%/active, 0.2%/reactive to 5000:1; Compliant with IEC62052-11, IEC62053-21, IEC62053-23

3-in-1 Ethernet Controller; TCP/IP + MAC + PHY; High Speed SPI; 32KB TX/RX Buffer

17.85x15.875, Warm White 3000K, CRI80, 1965lm@450mA/85C, 36V, 115deg

Lens Array Florence, Asymmetric Beam, Screw Fastening, Material-PMMA 286x61x11mm

Wi-Fi 2.4GHz, 802.11 b/g/n + Bluetooth LE v4.2 Module; ESP32-D0WDQ6, 32Mbits PSRAM, 32Mbits SPI flash; 2.3-3.6VDC; 18x31.4x3.3mm; PCB Antenna

Precision Digital Temperature+Humidity Sensor; I2C output; ±0.4°C / ± 3% RH; –40 to +85 °C; Filter Cover

UV Index and Ambient Light Sensor with I2C Interface

Pyroelectric Infrared Motion Sensor, PaPIRs; Detection Range: 5m / 94°|82° / 64 zones; 3-6VDC/170uA; Digital (OC); Black

Ultra Compact AC/DC; 10W; Uin:85-264VAC; Uout:12VDC; Iout:0.83A(1.08A Peak); Eff. 83%; -25°C to 70°C(Full power to 50°C)

DIN Rail; In. 90-132/180-264VAC; Out. 24V(22.5-28.5)/10A; -40°C to 70°C(Full power to 60°C); Eff. 89%; 111.3x83.0x125.0mm

DC UPS Adapter; In:90-264VAC; Out:12VDC/2.1A; Battery 3.7V/2600mAh; Input plug: Wall Mount / Output plug: DC Male Jack 4/1.7mm on 1m cable; 68x42x74mm

CC 700mA@159~214V; 200~277VAC; 94% Eff.;180x68x42.5mm; IP67

UPS; Line-Interactive, Simulated Sine wave; 800VA/480W; Backup@120W - 15 min; 12V/9.0Ah x 1; 279x101x142mm; Schuko x 2

UPS; Online, True Double-Conversion, Pure Sine wave; 1000VA/900W; 12V/9.0Ah x 2; PFC; SNMP through USB&RS-232; 282x145x220mm; Schuko+USB/RS232+INTSLOT

MPLAB® ICD 4 In-Circuit Debugger/Programmer

Atmel-ICE unit with enclosure loaded with normal firmware. Basick cable content (10 pin cable and USB cable)

WiFi Enabled PIC32MZ Microcontroller Board; Revision C; Based on PIC32MZ2048EFG100 MCU + MRF24WG0MA WiFi module

Artix-7 FPGA Development Board; Xilinx XC7A35TICSG324-1L FPGA; 33280 logic cells in 5200 slices; 90 DSP slices; On-chip XADC

Zynq-7000 Dual Core for ARM/FPGA SoC Dev. Board; Based on XC7Z010-1CLG400C + 667MHz Cortex-A9 processor + 512MB DDR3; Vivado and Petalinux support

Multi-Touch Display System; PIC32MZ + 2.8' QVGA 320x240; For use with Arduino, chipKIT and Arty platforms

LED Active Cooling Module O60x19mm; 2.8°C/W; for 25W A19 LED Bulb

Heatsink Passive; D99x160mm; TDP 49.4W; 1.01'C/W; Philips Fortimo SLM, Zhaga

Safety Relay/Forcibly guided contacts; 6A/250VAC, 30VDC; 24V/823Ohm; DPDT AgSnO2; Sealed

PhotoMOS-Signal-Relay, 1-Form-A, 60V/0, 5A, I/O=1, 5kV, Tape and Reel

Pushbutton Switch;Y LED Illuminated Actuator;10x10mm;SPST/OFF-ON;2.0N;50mA/24VDC

Vandal Resistant Switch; 3A/250V; 22mm; Ring Illumination Red; Stainless Steel; IP67

Compact Joystick/5-way navigation Thumb Control; Castle type actuator; Operating force 4N/11N; 1 million cycles; Sealed to IP67/IP69K

3 axis Hall Effect Joystick for PTZ Control (pan / tilt / zoom); Programmable pushbutton switches; USB 2.0 HID compliant; Black

SMD R/A 1P 4mm 250VAC/9A 24-18AWG white

RJ45 8P8C Waterproof Socket; Panel Mount; 2A per pin / 250V AC/DC; Operating Temperature: -40°C ~ +85°C; IPX67

USB 3.1; C-Type Receptacle; Right Angle; Middle Mount

SFP Connector; 20pin; 0.5A/30V; SMT Type; 5um Gold Plating

Osciloscope Probe 10:1, Max 300V CATIII, Grey

51-piece repair set for smartphones and tablets

The universal conformal coating for printed circuit boards

USB Oscilloscope 2ch. 30MHz 100Msps, Logic Analyzer and Variable Power Supply

Digital Discovery: Portable Logic Analyzer and Digital Pattern Generator